 |
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
| Datasheet File OCR Text: |
| MMIC Medium Level Mixer 800 - 1000 MHz Features q q q q q MD54-0004 V2.00 SO-8 PIN 8 .1497-.1574 (3.80-4.00) -B.2284-.2440 (5.80-6.20) .010(0.25) M B M Low Conversion Loss +21 dBm 1 dB Compression LO Drive Level: +11 to +23 dBm DC - 100 MHz IF Bandwidth Low Cost Plastic SOIC Package Orientation mark PIN 1 .1890-.1968 (4.80-5.00) -A.004 (0.10) Description M/A-COM's MD54-0004 is a passive mixer that achieves the performance of a double balanced diode mixer in a low cost surface mount plastic SOIC 8-lead package. The MD54-0004 is ideally suited for use where high level RF signals and very wide dynamic range are required. Typical applications include frequency up/down conversion, modulation, demodulation in systems such as cellular receivers and transmitters, and 900 MHz ISM band applications. The MD54-0004 uses FETs as mixing elements to achieve very wide dynamic range in a low cost plastic package. The mixer operates with LO drive levels of +11 dBm to +25 dBm. DC bias is not required. M/A-COM's MD54-0004 is fabricated using a mature 1-micron GaAs process. The process features full IC passivation for increased performance and reliability. * .0532-.0688 (1.35-1.75) 0-8 -C.0040-.0098 (0.10-0.25) .013-.020 TYP. (0.33-0.51) .0099-0.0196 x 45 Chamfer (0.25-0.50) .016-.050 (0.40-1.27) .0075-0.0098 (0.19-0.25) .050(1.27) BSC. .010(0.25) M C A M B S 8- Lead SOP outline dimensions Narrow body .150 (All dimensions per JEDEC No. MS-012-AA, Issue C) Dimensions in ( ) are in mm. Unless Otherwise Noted: .xxx = 0.010 (.xx = 0.25) .xx = 0.02 (.x = 0.5) Ordering Information Part Number MD54-0004 MD54-0004TR MD54-0004RTR MD54-0004SMB Description SOIC 8-Lead Plastic Package Forward Tape & Reel * Reverse Tape & Reel * Designer's Kit Standard reel size is 7 inches. If other reel size is required, consult factory for part number assignment. Electrical Specifications Test Conditions: RF = 900 MHz (-10 dBm), LO = 840 MHz (13 dBm), IF = 60 MHz, TA = +25C Parameter Test Conditions Units Min. Conversion Loss dB Isolation LO to RF dB 25 LO to IF dB RF to IF dB VSWR LO Port RF Port IF Port Input 1 dB Compression RF Freq. = 900 MHz, LO = +13 dBm dBm Two-Tone IM Ratio1 Two tones at -10 dBm each, Tone spacing = 100 kHz, IF = 60 MHz dBc 45 1. IMR vs RF drive level can be calculated by the formula: IMR = 45 - (1.5 x PIN). Typ. 7.5 38 22 12 2.5:1 2.0:1 2.0:1 +21 60 Max. 9.5 Specifications Subject to Change Without Notice. M/A-COM, Inc. North America: Tel. (800) 366-2266 Fax (800) 618-8883 s 1 Asia/Pacific: Tel. +81 (03) 3226-1671 Fax +81 (03) 3226-1451 s Europe: Tel. +44 (1344) 869 595 Fax +44 (1344) 300 020 MMIC Medium Level Mixer MD54-0004 V2.00 Absolute Maximum Ratings 1 Parameter RF Input Power 2 LO Drive Power 2 Operating Temperature Storage Temperature Absolute Maximum +22 dBm +23 dBm -40C to +85C -65C to +150C Spurious Table 4x HARMONIC OF LO (n) 3x 2x 1x 0x 8.9 -1.1 2.2 -7.7 2.9 -7.1 -2.2 -12.2 X X 0x 40.1 39.9 34.2 34.1 23.7 23.8 0 0 4.7 4.8 1x 70.1 61.6 59.8 63.8 72.8 64.7 61.4 63.3 65.1 61.3 2x 69.9 63.9 67.3 64.5 72.9 63.3 71.3 61.8 71.5 61.9 3x 73.4 64.4 73 63 71.9 61.9 71.1 61.9 72.1 62.3 4x 1. Operation of this device above any one of these parameters may cause permanent damage. 2. Total power for RF and LO ports should not exceed +23 dBm. Functional Diagram3 1 GND RF GND GND 4 5 8 GND IF LO GND HARMONIC OF RF (m) The spurious table shows the spurious signals resulting from the mixing of the RF and LO input signals, assuming down conversion. Mixing products are indicated by the number of dB below the conversion loss. The lower frequency mixing term is shown for two different RF input levels. The top number is for an RF input power of -5 dBm, the lower number is for -15 dBm. |mFRF - nFLO|, RF = -5 dBm |mFRF - nFLO|, RF = -15 dBm RF Frequency = 900 MHz LO Frequency = 840 MHz 3. External matching network on LO Port: R = 470 ohms, L = 18 nH, C = 4.7 pF Typical Performance CONVERSION LOSS VS FREQUENCY CONVERSION LOSS (dB) 10 9 8 7 6 5 800 850 900 950 1000 50 ISOLATION vs FREQUENCY, LO = +13 dBm LO to RF ISOLATION (dB) 40 30 LO to IF 20 RF to IF 10 0 800 850 900 950 1000 RF FREQUENCY (MHz) RF FREQUENCY (MHz) INPUT P1dB (dBm) 30 RF, LO and IF VSWR vs FREQUENCY, LO = +13 dBm IF FREQUENCY (MHz) 5 4 0 40 80 120 160 200 INPUT P1dB (dBm) P1dB @ LO = +13 dBm 25 IF VSWR 3 20 15 LO 2 RF 1 850 900 950 1000 0 800 840 880 920 960 1000 10 800 RF FREQUENCY (MHz) Specifications Subject to Change Without Notice. RF and LO FREQUENCY (MHz) 2 North America: Tel. (800) 366-2266 Fax (800) 618-8883 s M/A-COM, Inc. Asia/Pacific: Tel. +81 (03) 3226-1671 Fax +81 (03) 3226-1451 s Europe: Tel. +44 (1344) 869 595 Fax +44 (1344) 300 020 |
Price & Availability of MD54-0004TR
 |
|
|
|
|
All Rights Reserved © IC-ON-LINE 2003 - 2022 |
| [Add Bookmark] [Contact Us] [Link exchange] [Privacy policy] |
|
Mirror Sites : [www.datasheet.hk]
[www.maxim4u.com] [www.ic-on-line.cn]
[www.ic-on-line.com] [www.ic-on-line.net]
[www.alldatasheet.com.cn]
[www.gdcy.com]
[www.gdcy.net] |